Water Heater Repair Longview TX: Troubleshooting Your Electric Water Heater

Posted by on Jun 10, 2014 in Plumber Longview TX, Water Heater Installer Longview TX | 0 comments Nothing is more frustrating than turning on the water for a hot shower and finding out that there is no hot water.  The water heater is one of the appliances that you take for granted until it stops working.   The reason you can take it for granted is that most electric water heaters are built well and last many years.  But even the most well-built water heater can break down in many ways.  Before you call water heater repair Longview TX, check out these common electric water heater problems: No hot water.  The most obvious solution to this problem is to check your circuit breakers to see if one is tripped.  After the circuit breakers, the next thing to check is the reset button on the water heater limit switch.  The limit switch will shut your water heater off if something malfunctions.  A faulty thermostat or heating elements can cause your water heater to stop working as well. Not enough hot water.  The thermostat on your water heater could be the culprit when there isn’t enough hot water.  Loose wiring somewhere in the unit or heating elements that aren’t working correctly are also possibilities.  If you have an older water heater, your plastic dip tube could be disintegrating.  The dip tube carries cold water to the bottom of the tank. Water takes too long to reheat.  A thermostat adjustment may be needed to solve this problem.  The lower heating element could be bad or there could be sediment in the bottom of the tank.  A technician from  water heater repair Longview TX can test your heating elements and drain your water heater to remove the sediment. Water gets too hot.  This is probably caused by a thermostat that is either not working properly or that needs to be adjusted to a lower temperature. Rust-colored water.  Water from your tap could be rust-colored or even black.  Scale build-up on the heating elements is one possibility for this.  The other is a disintegrating anode rod – the anode rod keeps your heater tank from rusting. Water smells bad.  If a contamination in your city’s water supply is not the problem, you probably have a build-up of bacteria in your water heater.  Flushing the tank or replacing the anode rod may help. Leaking tank or pressure relief valve.  If water is leaking from the pressure relief valve, that indicates a faulty valve...
read more

Plumber Longview TX: What’s Wrong with your Hot Water Heater?

Posted by on May 12, 2014 in Commercial Plumbing Longview TX, Water Heater Installer Longview TX | 0 comments The hot water heater is an essential part of your home plumbing system. If you suspect that something is wrong with it, you might want to contact a plumber Longview TX to look at it. You never know if the problem you have is a common and easily fixed problem or one of the more rare and severe problems, without the help of an expert. Here are a few of the most common problems with a hot water heater, and what you can do if yours starts to show signs of having one of them: 1. No hot water or not enough The primary job of your hot water heater is to ensure you have constant access to water in the temperature you need. From cooking to bathing, hot water is a valued commodity in the modern home. When your’s fails to produce any hot water, or consistently fails to provide it in adequate quantities, it could be the sign of a bad pilot light or thermostat. If your heater is not providing adequate heat, you might want to call a plumber Longview TX to check for one of the common causes. 2. Leaking While the occasional drip can be dismissed as being due to condensation, if you find large puddles consistently around the base of your heater or the pipes, you might want to be concerned. Leaks can happen for a number of reasons and in a number of places. If you cannot spy any obvious sources of the leak, you might want to contact a plumber Longview TX to look at your heater to spot it. Leaks can be dangerous, causing everything from mold to a flood. If you suspect that your heater is leaking, don’t hesitate to contact a professional. 3. Water has odd color or smell This problem is so common it has practically become shorthand comedy to indicate an old or primitive plumbing system. However it can happen in even the most modern homes. Bacteria in your tank can sometimes cause a foul odor, and the color of the water can change when rust contaminates it. If your water changes in such a way, it might need to be flushed out. Do not ignore possible problems with your hot water heater. If you suspect that your heater has succumbed to one of the problems outlined above, or it is in anyway not performing as...
read more